Yukon Analysis Constructing Base Map
Simple Base Map
The simple base map is constructed out of 2 simple raster data sources, these data sources are pipelines that are read into WorldView using pipelines and integrated on the PYXIS DERM to produce one coherent map.
Data Sources Used
- We start with a low resolution image provided from the World.topo.bathy datasource.
- However due to the low resolution of this data source it is going to be difficult to perform an indepth analysis which will yield highly acurate and meaningful results. Therefore it it necessary to upload a higher resolution data source of the specific area in which we are interested.
- Open YukonMosaic90mNoClouds.tif in WorldView.
- Clearly this high resolution map of the Yukon would make an ideal base map to perform our analysis on. However because the edges are masked out and clearly there is data that has been lost. It is possible to run into situations where the data we want to analyze extends off the edge of the map that data is present for, as indicated in the image below.
- From the areas highlighted it is difficult to interpret this data without some form of context applied to the data. To help gain a better understanding of the data highlighted above we integrate the high resolution Yukon Mosaic map with a lower resolution World.topo map to provide context to the areas that have been filtered out of the Yukon Map. After integration our base map looks like.
- In our integrated base map you can see that the areas previously masked out in the high res map of the Yukon Territory are now filled in with data from our lower resolution map.
This will be the base map which will be used for performing analysis on the Yukon Territory in Yukon Analysis
Complex Base Map
This base map was generated from data found at the Yukon Geomatics department's ftp site. It was done only to demonstrate how quick and easy it is to generate a highly detailed highly accurate base map using WorldView.
Data Sources Used
Each image is going to show one step in making the map I will document the changes in the image from step to step
Start with a low resolution raster image.
Open a vector file Yukon_polygon.shp outlining the area we're interested in.
Open higher resolution raster imagery file YukonMosaic90mNoClouds.tif to fill in the area we're interested in making a map for.
Open a vector file roads_line.shp describing the road network in the Yukon
Open a vector file rivers_line.shp describing the river network in the Yukon
Open a vector file contours_line.shp describing the river network in the Yukon
NOTE: I also hid the library and the properties by unchecking the check boxes at the top of the screen to see more of the image
Zoom in on the contours to see them at a medium resolution rather then a low resolution as show above.
Zoomed in to Higher resolution then shown above and opened an elevation data source
Titled the map to better examine the full base map with an elevation data source open